PL5500 High Efficiency 4-Switch Bidirectional Buck-Boost Controller

PL5500 High Efficiency 4-Switch Bidirectional Buck-Boost Controller

1 Features

 Bidirectional single Inductor Buck-Boost Controller

for Step-Up/Step-Down DC/DC Conversion and

battery charge management  Bidirectional buck-boost operation to support battery

charging and discharging using OTG signal  Dynamical programming of input current, Output

current and Output voltage using PWM signal or

analog signal  1 Cell to 6 Cells battery charge management  2V to 32 V wide output range

 Comprehensive protection features including Output

Short Protection (OSP), Cycle-by-Cycle input and

output Peak Current Limit, thermal regulation,

thermal shutdown, input UVLO, input OVP, output

OVP etc.  Adjustable Switching Frequency using resistor  Frequency dithering for good EMI performance

 Integrated 2-A MOSFET Gate Drivers

 Input or Output Average Current Limiting with stable

CC loop

 Available in QFN4x4-32 Package

2 Applications

 Automotive Start-Stop Systems

 Backup Battery and Super capacitor Charging

 Industrial PC Power Supplies

 USB Power Delivery

3、Description

PL5500 is a synchronous 4-switch bidirectional Buck-Boost controller capable of regulating the output voltage at above or below the input voltage. PL5500 operates over a wide input voltage range of 3.6 V to 32 V (36 V maximum) to support a variety of applications. PL5500 can operate at charger mode for 1, 2, 3, 4, 5 and 6 cells battery charge. PL5500 employs Constant ON time control in buck, boost and buck-boost operation modes for superior

load and line regulation. The switching frequency could be set to 150kHz, 300kHz, 600kHz or 1200kHz based on different resistor value between FREQ pin and GND pin. The device also features a programmable soft-start function and offers all kinds of protection features including cycle-by-cycle current

limiting, input under voltage lockout (UVLO), output over voltage protection (OVP), input Over Voltage Protection, thermal shutdown and output short

protection etc. VADJ, IADJ pins are used to program output VBUS voltage and output current limit at battery discharging mode when OTG is high, which makes PL5500 an excellent option for USB Power Delivery (PD)

application. PL5500 provides voltage control loop, constant current loop, thermal regulation loop, battery temperature sensing, which makes it a perfect

solution for batter charge management.

4、Website：www.baitaishengshi.com

5、Typical Application Schematic